Advertisement
Step 17: With the new cable, start by laying the cable
over the top of the carriage as shown. NOTE: No
cable ties at this point.
Step 19: A close up of the carriage board. Power,
head 1 head 2 etc...NOTE: VERY IMPORTANT TO
ATTACH THE POWER CABLE CONNECTOR TO THE
POWER RECEPTOR (ARROW).
Step 21: Shown 3 cables as it should look.
Step 23:Place the 6 cable ties in the holes on the car-
raige top plate and wrap them around the white ribbon
cable as shown.
Step 18: Turn the carriage over.
Step 20: There is a blue stripe on each cable. NOTE:
That blue stripe MUST connect to the Number 1
pin (see step 19 yellow arrows).
Step 22: A side view. All 3 are placed correctly. All pins
covered (rows and columns).
Step 24: Once cinched down tight, snip off the excess
as shown.
3
14140 NE 200th St.
Woodinville, WA 98072
1.425.398.8282
www.ioline.com
Advertisement
