Honda CITY 2021 Manual page 80

■
Installing a Child Restraint System with a Lap/Shoulder Seat
Belt
A child seat can be installed with a lap/shoulder belt in any rear seat or, if absolutely
necessary, the front passenger seat.
Tab
1. Place the child restraint system on the
vehicle seat.
2. Route the seat belt through the child
restraint system according to the child
restraint system manufacturer's
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
Models without lockable retractor
3. Push down the tab. Route the shoulder part
of the belt into the slit at the side of the
restraint.
4. Grab the shoulder part of the belt near the
buckle, and pull up to remove any slack
from the lap part of the belt.
u When doing this, place your weight on
the child restraint system and push it into
the vehicle seat.
5. Position the belt properly and push up the
tab. Make sure the belt is not twisted.
u When pushing up the tab, pull up the
upper shoulder part of the belt to
remove any slack from the belt.
uuChild SafetyuSafety of Infants and Small Children
1Installing a Child Restraint System with a Lap/Shoulder Seat Belt
Models with lockable retractor
To check if the lap/shoulder belt is equipped with the
lockable retractor, pull the shoulder part of the lap/
shoulder belt all the way out, let the belt retract
slowly, then pull the belt again gently. If the belt is
locked, the belt is equipped with the lockable
retractor.
The seat belt with a lockable retractor has a label as
shown in the image.
All models
A child restraint system that is not properly secured
will not adequately protect a child in a crash and may
cause injury to the child or other vehicle occupants.
Continued 79