Sunjoy D-UM111PST Assembly Instructions

IMPORTANT:

1. Keep all children and pets away from assembly area. Children and pets should be supervised while product is being

assembled.

2. The assembled product should be located at least 6 feet (2 m) from any obstruction such as fence, garage, house,

overhanging branches, laundry lines or electrical wires.

3. This unit is heavy. Do not assemble this item alone. Two people are recommended for safe assembly.

4. Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.

5. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of

personal injury and damage to equipment. Please read all instructions before assembly and use.

6. For outdoor use only. Install on level ground.

7. Check all bolts for tightness before and during usage.

8. Please check your state and local regulations prior to purchasing. Some jurisdictions may require permits for

installation and use. Some special procedures may be valid in your area.

9. While this umbrella is manufactured to withstand strong force winds through only the supplied ground stakes, in

areas subject to frequent severe weather, securing the umbrella to a deck, concrete patio or footings should be

considered.

NOTE: The product's structure is not guaranteed against extreme weather conditions (storms, high winds, etc.). If the

product is not dismantled for the winter, snow must be cleaned off regularly. Any damage caused by snow

accumulation is not covered by the warranty.

Care & Maintenance:

Our steel components for garden accessories and furniture are treated with rust inhibiting paint that protects it from

rusting. However, due to the nature of steel, surface oxidation (rusting) will occur once these protective coatings are

January 16

Item# D-UM111PST

Made In China

1 / 3

Table of Contents

Do you have a question about the D-UM111PST and is the answer not in the manual?

Page 1 Assembly Instructions Item# D-UM111PST IMPORTANT: 1. Keep all children and pets away from assembly area. Children and pets should be supervised while product is being assembled. 2. The assembled product should be located at least 6 feet (2 m) from any obstruction such as fence, garage, house, overhanging branches, laundry lines or electrical wires.
Page 2 scratched. This is not a defect and thus not covered by the warranty. To minimize this condition, we recommend care when assembling & handling the product to prevent scratching the paint. Should any scratching or damage occur, we recommend immediate touch-up with rust inhibiting paint. Surface rust can also be easily removed with a very light application of common cooking oil.
Page 3 Step 1: Attach Base frame 1 (A) to Base frame 2 (B) by cross placement as Fig. 1 show. Step 2: Attach Base tube (C) to base frame with E and D as Fig. 2 show. Step 3: Place Umbrella (F) to base frame and then secure it with knob pre-assembled on tube C as Fig. 3 show. Step 4: Raise up the handle upward as Fig.4 show.