Board Exchange
4.1
Introduction
This chapter describes how to install the Centellis 2000 User Card-10GE board and includes the
following information:
Before installation
Installing the board in a shelf
Starting up the board
Removing the board
Operation
The system is shipped with pre-installed Centellis 2000 User Card-10GE boards. You have to
observe the following procedures when ordering a board as a spare part or exchanging a
board.
4.2
Before Installation
This section provides the following information:
Requirements
Unpacking and inspecting the board
4.2.1
Requirements
Before you power up the board, calculate the power needed according to your system
configuration.
Centellis 2000 User Card-10GE Installation and Use (6806800H33B)
Chapter 4
35