Advertisement
Attaching the shaft parts and string
Cut out the shaft parts and
glue the halves together at the back.
Assemble the shaft holder, and insert the shaft
Glue
Cut out the shaft holder parts and
glue the halves together at the back.
How to fly your paper copter
Gently hold down the string with your thumb
so that is doesn't get tangled up inside,
and rotate the shaft clockwise
to wrap the string around it.
Paper Copter /
Assembly Instructions
Attach the shaft parts
to the tip of the shaft.
Attach the shaft holder
into a cylinder shape.
View from above
Attach the string
and stopper to the shaft.
Grab it with a finger, and pull it out.
Insert the shaft into the shaft holder,
and pull the string out through the hole.
Set the propeller on the shaft, and swiftly pull the string.
If it doesn't fly well, try adjusting the speed
you pull the string with or the amount of strength you use.
Glue the string firmly
so it doesn't come off.
Put glue at the start and
end to attach the piece.
(about 70cm)
Glue
Finally, attach the tag
to the end of the string.
Face the side
with the circle up.
Rather than holding
just the tag, hold the string
as well and pull.
Advertisement
