Mounting The Cbd6Dc On The Bed Frame; Electrical Connection; External Power Supply - Linak HOMELINE CBD6DC User Manual

Mounting the CBD6DC on the bed frame

1. Mount CBD6DC using two screws with a head diameter of 10 mm (8 to10 mm can be used).
2. Fasten mounting screws (max. torque 1 Nm).
Notes:
• The surface to which the control box is mounted should have an evenness better than ± 0.5 mm.
• The control box can also be mounted using one or two M6 nuts and screw counterparts, see Drawing appendix.
• The power plug must be accessible when the CBD6DC is mounted so that the supply to the CBD6DC can be
disconnected if replacement is required.

Electrical connection

External power supply

The CBD6DC is compatible with Switch Mode Power Supply SMPS001, SMPS002 and SMPS006.
1. Connect the actuator motor cable(s) to plug(s) 1 (and 2).
2. Connect any other accessories/devices.
3. Connect the external power supply (SMPS) to the CBD6DC.
Page 14 of 20