Canon 800II Installation Manual page 29

<Counter Settings>
When a counter is set in a text string, use these settings to specify the size of the
counter increment and the increment trigger.
Increment Trigger
Select one of the following as the trigger for incrementing the number on the
counter.
[New File]
Increments the counter when a new file command is used to change to a new file.
[File Mark]
Increments the counter at each file mark on the film.
[Batch Mark]
Increments the counter at each batch mark on the film.
[File/Batch Mark]
Increments the counter at each file or batch mark on the film.
[Each image]
Increments the counter at each scanned image.
[None]
The counter is not incremented.
The [File Mark], [Batch Mark] and [File/Batch Mark] settings are valid
when the FS Controller III is used. Refer to the FS Controller III In-
NOTE
structions for details.
Increment
Sets the amount (0 to 255) by which the counter is incremented.
Reset Trigger
Select one of the following as the trigger for resetting the counter.
[New File]
Resets the counter when a new file command is used to change to a new file.
[File Mark]
Resets the counter at each file mark on the film.
[Batch Mark]
Resets the counter at each batch mark on the film.
[File/Batch Mark]
Resets the counter at each file or batch mark on the film.
[Each image]
Resets the counter at each scanned image.
[None]
The counter is not reset.
Chapter 2 Specifying the Scanner Settings
2
29