GE AEN10AP Owner's Manual And Installation Instructions page 11

PREPARE THE AIR CONDITIONER
3
(cont.)
Attach the accordion panels to the case
C
using 3 Type A screws on each side.
Accordion
panel
Type A
screws
PREPARE THE WINDOW
4
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
Installation Instructions
Top mounting rail
BACK
Bottom mounting rail
INSTALL THE AIR CONDITIONER
5
IN THE WINDOW
A
Place the air conditioner on the stool with
the bottom mounting rail against its back
edge. Center it and close the window
securely behind the top mounting rail.
It should be level or slightly tilted to the
outside. Use a level; about a 1/3 bubble
will be the correct case slant to the outside.
or
Extend the left and right accordion panels
B
to the vertical window sashes and attach,
through the holes in the panels, with 4
Type C screws, as appropriate.
INSTALL A SUPPORT BRACKET
6
AND THE FOAM TOP WINDOW
GASKET
A
Attach the support bracket with one
Type C screw.
B Cut the foam top window gasket to the
window width.
C Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
11
or
Type C screws