Sony TDM-BT10 Operating Instructions Manual page 12

To finish connecting
Terminate the Bluetooth connection by any of the operations below.
Operate the Bluetooth audio source device to terminate the connection. For

details, refer to the operating instructions supplied with the device.
Turn off the Bluetooth audio source device or the AV system.

Press the OPR button momentarily. When the disconnection is complete, the

indicator flashes slowly.
Note
In the following cases, you need to make the Bluetooth connection again.
The Bluetooth connection is disconnected once.

The power of the Bluetooth audio source device does not turn on, or the

Bluetooth signal is off.
The Bluetooth audio source device is in sleep mode.

The Bluetooth connection has not been established.

To turn off the Bluetooth signal
Even if you stop Bluetooth communication with the Bluetooth audio
source device, this unit continues to send out signals. You can stop the
signal completely by the operations below.
When the indicator is on (When the Bluetooth connection is established):

Press momentarily the OPR button to stop Bluetooth communication with the
Bluetooth audio source device. (The indicator flashes.) Then press momentarily
the OPR button again to turn off the signal from the unit. (The indicator turns
off.)
When the indicator is flashing (When the Bluetooth connection is possible):

Press momentarily the OPR button to turn off the signal from the unit. (The
indicator turns off.)
1
GB