Using The Remote Controller Holder(Optional); Replacing Batteries - Bosch RG57A6 User Manual

User Manual

6.2 Using the remote controller holder(optional)

The remote controller can be attached to a wall or pillar by using a remote controller
holder.
1. Before installing the remote controller, check that the air conditioner receives
the signal properly.
2. Install the remote controller holder with two screws.
3. For installing or removing the remote controller, move it up or down in the
holder.
Figure 13

6.3 Replacing batteries

The following cases signify exhausted batteries. Replace old batteries with new ones.

Receiving beep is not emitted when a signal is transmitted.

Indicator fades away.
The remote controller is powed by two dry batteries (Alkaline AAA x 2) housed in the
back rear part and protected by a cover.
1. Remove the cover in the rear part of the remote controller.
2. Remove the old batteries and insert the new batteries,placing the(+) and (-)
ends correctly.
3. Re-install the cover.
Figure 14
Bosch Thermotechnology Corp. | 12.2016
Bosch Remote Controller for Split Type Ductless Air Conditioner / Heat Pump | 13
When the batteries are removed, the remote controller erases all
settings and timers. After inserting new batteries, settings and timers
must be reset.
CAUTION:

Do not mix old and new batteries or batteries of different
types.

Do not leave the batteries in the remote controller if they are
not going to be used for 2 months or longer.

Dispose of batteries properly, per local and national codes or
requirements.
Data subject to change