Advertisement
CONNECTING BAR FASTENERS
DRIVE SHAFT SEALING
8.1
8.2
Apply Silicone Sealant
(not supplied) to ends
of Connecting Bar
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
6
CYLINDER ADJUSTMENT
Adjust the Cylinder Flow
Control Screw to allow
approximately 3 seconds
time for the ladder to glide
down when operating the
loaded Ladder Rack.
NOTE: This completes the right hand assembling of FEA-0015.
For left side Drive Shaft assembly procedures, see FEA-0016
Assembly Manual.
If applicable, refer to your next FEA Assembly Manual.
If completed, refer back to your FBM Assembly Manual, and
resume assembling at Step 3.1.
WARNING: Failure to position the Crossbars as shown in your
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
7
7
Advertisement
