Advertisement
4
RIGHT DRIVE SHAFT
ASSEMBLY SEQUENCE
NOTE: Crossbars and RH Rotation feature
are shown for illustrative purposes only.
Crossbars and Rotations are not included
with this Drive Shaft feature, and must be
purchased separately.
NOTE: Flow Control Screw
faces toward vehicle rear
REAR DRIVE SHAFT
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
2/7
1.1
1.2
1.3
Torque to
90 in-lbs
8
3
1
CYLINDER HARDWARE
NOTE: Loosen the Cylinder Flow Control Screw (Fig.
C) as needed to allow movement for Steps 2.1-2.2.
When finished with Cylinder Hardware, tighten the
Flow control Screw all the way closed then turn back
open 1½ turn.
5
6
4
2.2
2.1
Advertisement
