Advertisement
HANDLE LATCH ASSEMBLY
3.2
Remove and retain
for Step 3.4
Apply Anti-Seize Compound to the Hardware removed during
3.5
Step 3.1, then install Hardware into Handle Clamp Body.
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
3.3
3.1
Remove and retain
for Step 3.5
3.1
Remove and retain
for Step 3.5
3.6
As shown in Figure A, lightly pull the Release Latch outward
prior to setting the Latch Assembly onto the Drive Shaft.
Figure A
Position the Handle Latch Assembly with
the Rotation in its full resting position.
The Handle must engage the Crossbar
Interlock before final tightening.
Note: To prevent damage to
the Release Latch, do not
rotate the lever beyond the
position shown in Figure A.
Approximate
positioning
Slide into Handle
3.4
Clamp Body
3.7
Torque to 90 in-lbs
Handle must engage
the Latch as shown.
5
Advertisement
