New Holland 8010 Service Manual page 18

INTRODUCTION
Do not use damaged or defective tools or equipment, particularly high speed equipment such as grinding wheels. A
damaged grinding wheel can disintegrate without warning and cause serious injury.
Wear suitable eye protection when using grinding, chiselling or sand blasting equipment.
Wear a suitable breathing mask when using sand blasting equipment, working with asbestos based materials or using
spraying equipment.
Glues
See adhesives and sealers.
High pressure air, lubrication and oil test equipment
See lubricants and greases.
Always keep high pressure equipment in good condition and regularly maintained, particularly at joints and unions.
Never direct a high pressure nozzle at the skin as the fluid may penetrate to the underlying tissue etc. and cause
serious injury.
Legal aspects
Many laws and regulations make requirements relating to health and safety in the use of materials and equipment in
workshops.
Workshops should be familiar, in detail, with associated laws and regulations. Consult local factory inspectorate if in
any doubt.
Lubricants and greases
Avoid all prolonged and repeated contact with mineral oils, especially used oils. Used oils contaminated during service
(e.g. routine service change sump oils) are more irritating and more likely to cause serious effects including skin
cancer in the event of gross and prolonged skin contact.
Wash skin thoroughly after work involving oil. Proprietary hand cleaners may be of value provided they can be re-
moved from the skin with water. Do not use petrol, paraffin or other solvents to remove oil from the skin.
Lubricants and greases may be slightly irritating to the eyes.
Repeated or prolonged skin contact should be avoided by wearing protective clothing if necessary. Particular care
should be taken with used oils and greases containing lead. Do not allow work clothing to be contaminated with oil.
Dry clean or launder such clothing at regular intervals. Discard oil soaked shoes.
Do not employ used engine oils as lubricants or for any application where appreciable skin contact is likely to occur.
Used oils may only be disposed of in accordance with local regulations.
There are publications describing the problems and advising on precautionary measures.
Noise insulation materials
See foams, fibre insulation.
Paints
See solvents and chemical materials - general.
Highly flammable, flammable.
One pack
Can contain harmful or toxic pigments, driers and other components as well as solvents. Spraying should only be
carried out with adequate ventilation.
47866579 08/01/2016
13