Right-hand Rear View
FIG. 8: Right-hand rear view
(1)
Knotter blower fan
(2)
Knotter trip linkage
(3)
Knotter brake
Right-hand Auxiliary Drive View
FIG. 9: Right-hand auxiliary drive
(1)
Stuffer and pickup shearbolt
(2)
Knotter shearbolt (not shown)
(3)
Knotter clutch assembly
(4)
Knotter drive chain
(5)
Stuffer and pickup drive chain
GENERAL MAINTENANCE INFORMATION
Periodically inspect all bolts, sprockets, roller chains, and
bearing lock collars. Tighten any components that are
loose. When tightening bolts, check the procedure for the
required torque values. DO NOT over tighten bolts as this
can cause a bolt to fail during operation.
Bolt Torque Values
All bolts used on this baler are Grade 5 plated bolts
unless specified. Always replace with Grade 5 hardware
except where higher grades are specified. All Grade 5
bolts have three radial marks on the bolt head. Tighten all
hardware according to the following charts unless
specified differently in the manual.
See the Specifications division for wheel hardware torque.
4283475M2
General Information
1
3
2
FIG. 8
5
1
FIG. 9
3
T0214140
4
3
2
T0214129
01-7