How To Take Care Of Your Runner - Renegade ARUN050 Instruction Manual

How to Take Care of Your Runner

Storage
Keep the equipment in a dry place with as little temperature variation as possible. Try to protect from dust and always unplug
when not in use (if applicable).
The safety level given by the design of this runner can only be maintained when this runner is regularly examined for damage
and wear. Inoperable components should be replaced immediately or this runner should be put out of use until it is repaired
!
Never remove the protective casing.
Your runner is designed for indoor exercising used only and should not be used or stored in damp areas.
Ensure you regularly check components for wear and make sure all the nuts & bolts are tightened before each exercise session
Maintenance Tips
•
Always use a soft, cotton cloth and dilute non-abrasive cleaner or a mid detergent for cleaning the exterior of this runner.
•
Never use ammonia, acid-based, or petroleum-based solvents on any portion of the runner as it may damage the finish.
Preventative maintenance Schedule
Daily –
•
Before each use, check that slat running mat are securely tightened and inspect each slat for wear.
•
After each use, wipe down the surface of the runner to remove sweat and moisture.
•
Wipe the face of the display console with a slightly damp, soft, cotton cloth. Avoid getting extra moisture on the display
console. Keeping the display console free of fingerprints and sweat will extend the life of the console.
Weekly –
•
Thoroughly clean the plastic housing of the runner.
•
Clean the top of the handlebar, side post, slats and the display console.
•
Check that slats are securely tightened and inspect each slat.
•
Inspect all assembly bolts & nuts for wear and ensure that they are sufficiently tight.
Monthly –
•
Make sure all of the open ends of metal parts are wiped with thin grease to protect from rust.
•
Check and Replace the Console AA Battery if needed.
•
Clean for dust on running slat Assembly by spray gun if available.
!
We do not recommend you attempt to service the internal parts of the running slat assembly.
If they are found to be worn internally, we recommend replacing the running slat.
!
Use of lubricants or cleaning solutions other than those so specified will result in diminished
16
performance and a shorter life span for that part.