Rampage 14301 Bracket Installation

RAMPAGE
P R O
(6x) 8mm bolts
(12x) 6mm bolts
Ratchet wrench with extension
NOTE: Before installation please read and understand these instructions. Please be sure all
of the components are included in the package. Please be sure to have a helper to assist you
for the initial installation of the step assemblies.
Preperation
If the vehicle had factory step or rocker guard on it the pinch
clips will be installed on the floor of the vehicle already. If it did
not then they will need to be installed in the openings under the
vehicle as shown. Look for the square holes with a round hole
next to it. These mounting locations will require the pinch clips.
Slip them into the square holes and onto the round hole as
shown to the right.
D U C T S
(6x) 8mm ID washer
(24x) 6mm ID washer
Left side brackets

Tools Required

Thank You for purchasing this product!
14301 bracket installation
Jeep JK 4 door, 2007-

Parts List

Right side brackets
10mm socket
(4x) 8mm Pinch clip
(12x) 6mm nut
10mm wrench
Vehicle floor
(4x) 8mm Pinch clip
Vehicle floor
(4x) 8mm bolts
(6 x) U Bracket
13mm socket