Table of Contents
Advertisement
INTRODUCTION
FIBER INSULATION
See Dust.
Used for soundproofing.
The fibrous nature of cut surfaces and edges can cause skin irritation. In general, the effect is physical and not
chemical.
You must take precautions to avoid excessive skin contact. Take care when organizing your work methods. Wear
sleeves.
FIRE
See Welding, Foams, and Legal aspects.
Many materials relating to vehicle repair are highly flammable. Some release toxic or harmful fumes when burned.
Scrupulously obverse the fire prevention safety recommendations when storing and handling flammable materials or
solvents, particularly in the vicinity of electrical equipment or welding processes.
Before using any electrical or welding equipment, check that there is no fire risk.
Always keep a suitable fire extinguisher close by when using welding or heating equipment.
FIRST AID
In addition to complying with legal requirements, it is always advisable for someone in the workshop to be trained in
first aid procedures.
You must flush splashes in the eyes with clean running water for at least ten minutes.
You must wash contaminated skin with soap and water.
You must take individuals who have inhaled harmful fumes into the fresh air immediately.
If someone has ingested the substance or if the effects persist, consult a doctor with the information (label) on the
material used.
Do not induce vomiting (except where indicated by the manufacturer).
FOAMS – polyurethane
See Fire.
Used for soundproofing. Cured foams used in seat cushions and finishes.
Follow the manufacturer's instructions.
Components that have not reacted are irritants and could be harmful to the eyes and the skin. Wear sleeves and
protective goggles.
Individuals with chronic respiratory illnesses, asthma, bronchial problems, or a history of allergic illnesses must not
work with or be in proximity to uncured materials.
Components, fumes, and aerosol clouds can cause irritation and sensitization reactions, and may be toxic or harmful.
You must not breathe in fumes or aerosol clouds. You must apply these materials with adequate respiratory protection
and adequate ventilation. Do not remove the respirator when you have finished spraying, but keep it on until the fumes
and clouds disperse.
Burning uncured components and cured foams can generate toxic and harmful fumes.
Do not permit smoking, the presence of naked flames, or the use of electrical equipment during the application of
foam, and until the fumes/clouds have dispersed.
You must hot cut cured or partially cured foams in an environment with a ventilation system with extraction (see
Section 44 Legal and safety aspects).
Fuels
See Fire, Legal aspects, Chemicals – general, and Solvents.
Used as fuels and cleaning materials.
Gasolene (Petrol).
Highly flammable.
Ingestion can cause irritation to the mouth and throat, and absorption by the stomach can cause dizziness and loss
of consciousness. Small amounts can be fatal to children. Breathing liquid into the lungs – e.g. by vomiting – is a
serious risk.
Prolonged or recurrent contact with gasoline dries out the skin and causes irritation and dermatitis. Getting the liquid
in the eyes causes severe pain.
48079508 27/07/2017
14
Advertisement
Table of Contents
