Installation & Safety Instructions - DENAFRIPS TERMINATOR-PLUS Owner's Manual

1. INSTALLATION & SAFETY INSTRUCTIONS
This DAC is designed and built to provide trouble-free performance, but as with all
electronic devices it is necessary to observe a few precautions:
 Unpack the DAC carefully. It weights 20KG. Have a second person to assist would be
helpful.
 Position the DAC on a stable, horizontal surface, i.e. sturdy rack. Please use the spike
shoes provided for vibration control and protection of the surface.
 The DAC supports voltage 100-250VAC worldwide voltage. Please connect the AC
power cord with earth(ground) pin unless it is absolutely required to reduce hum
from the ground loops of the connected devices.
 Always ensure that when disconnecting and reconnecting your audio equipment the
mains supply is turned off.
 Position the power cord and signal interconnects where they are not likely cause trip
and fall hazard.
 Do not use the DAC near water, or place water-filled containers on the DAC. Entry of
liquid into the DAC is hazardous and may cause electric shock and/or fire hazard.
 Do not place the unit under direct sunlight or heat source.
 Do not remove any covers or try to gain access to the inside. There are no user
adjustments or fuses to change without qualification.
 Clean regularly with a damp soft cloth. Do not use any cleaning agents as it might
damage the surface finishing.
 The electronics in modern hi-fi equipment is complex and may, therefore, be
adversely affected or damaged by lightning. For protection of the audio system
during electrical storms, disconnect the mains plugs.
© DENAFRIPS CO. LTD. & VINSHINE AUDIO PTE. LTD. (SINGAPORE)
ALL RIGHTS RESERVED