Stihl RMI 632 Instruction Manual page 78

Hide thumbs Also See for RMI 632:
Table of Contents

Advertisement

Message:
2000 – Signal problem
Dock iMow
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the robotic mower in the docking
station – then press OK
Message:
2010 – Replace mowing blade
Allowed operating time reached
Possible cause:
– Mowing blade has been in use for more
than 200 hours, replacement is
necessary
Remedy:
– Replace the mowing blade, then
confirm the blade replacement in the
"Service" menu (
16.4)
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
– Machine service recommended
Remedy:
– Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
– Battery replacement necessary
Remedy:
– Have the battery replaced by a STIHL
specialist dealer
76
Message:
2031 – Charging failure
Check charging contacts
Possible cause:
– Charging cannot be started
Remedy:
– Check the charging contacts on the
docking station and robotic mower and
clean if necessary – then confirm the
message with OK
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (
shorten the mowing duration (
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return the robotic mower to the mowing
area and dock to charge the battery
(
15.7)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
6.4)
– Repeat edge following (
– Contact a STIHL specialist dealer for a
detailed diagnosis
11.7) or
11.8)
11.14)
0478 131 8349 A - EN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rmi 632 pRmi 632 cRmi 632 pc

Table of Contents