3-5-7. CN-1817 Board
Removal
1. Remove the top plate. (Refer to Section 3-2-2.)
2. Remove the rear panel assembly. (Refer to Section 3-
2-2.)
3. Remove the reusable band.
4. Remove the connector (CN6) of the CN-1817 board.
5. Remove the eight screws for connector.
MAV-555
Reuseable band
CN-1817 board
CN6
Screws for connector
Installation
Attach a new CN-1817 board by reversing the disassembly
procedure of steps 1 through 5.
m
. When attaching the screws for connector, apply locking
compound slightly.
. When attaching the reusable band, route the fan harness
under all other harnesses, and pull and end of the fan
harness toward the SDI connector.
. When attaching the rear panel to the MAV-555, remove
the slack from the harnesses between fans and others.
3-5. Replacing the Board
3-23 (E)