Advertisement
Quick Links
ODS DOUBLE SIDED KIOSK
OBELISK DIGITAL SIGNAGE SYSTEM
Max Weight:
60kg
Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier claims agent and
do not continue the installation until it has been reviewed. Please watch for pinch points. Do not put your fingers between
moveable parts. Do not tamper with or disassemble any spring loaded parts. Before installing, make sure that the supporting
surface will support five times the combined load of the solution and the hardware. Never exceed the maximum load
capacity. Please also layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or personal injury. This
product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or
lifting equipment to lift and position products. For support, please call: +44 (0)1865 767676.
WARNING
01865 767676
sales@unicol.com
www.unicol.com
Revised 25/10/19
Advertisement
Related Manuals for Unicol ODS DOUBLE SIDED KIOSK
Summary of Contents for Unicol ODS DOUBLE SIDED KIOSK
- Page 1 01865 767676 sales@unicol.com www.unicol.com ODS DOUBLE SIDED KIOSK OBELISK DIGITAL SIGNAGE SYSTEM Max Weight: 60kg WARNING Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier claims agent and do not continue the installation until it has been reviewed. Please watch for pinch points. Do not put your fingers between moveable parts.
- Page 2 01865 767676 sales@unicol.com www.unicol.com 13mm 4 & 5mm (Preferably ratchet spanner) COMPONENTS DESCRIPTION DESCRIPTION 2m Uprights Alternative bolt down base ODS Freestanding base M8x16 Hex head machine screw Top cover M8x20 Hex head machine screw Bottom cover Revised 25/10/19...
- Page 3 01865 767676 sales@unicol.com www.unicol.com M8x16mm Cable run M8x16mm M8x20mm M8x16mm STEP 2 STEP 1 IMPORTANT: Place cables in uprights. Screw in M8x16mm hex head screws into top two Slot uprights onto screen so that it is flush with fixings in screen - leave at least 2mm gap in order bottom of the cut out within the uprights.
- Page 4 01865 767676 sales@unicol.com www.unicol.com STEP 5 STEP 6 Locate the bottom cover and slide it into position. Looking underneath the bottom cover, tighten the The open end should be facing down and the two two fixing screws. Ensure that the cover is flush small cutouts facing up.