Table of Contents
Advertisement
Adjustment Procedure
The remote control is used for entering and storing adjustments, with the exception of cut-off adjustments which must always be done prior to
service adjustment. Perform adjustments in accordance with screen display. The display on the screen also specifies the CCU variants as
well as the approx. setting values. The adjustment sequence for the service mode is indicated below.
1.
Set the Bass to maximum position, set the Treble to minimum
position, press the Reveal button on the remote control and
at the same time press the -/v button on the customer
controls at the front of the TV, this will place the TV into the
Service Mode.
2.
Press the RED / GREEN buttons to step up / down through
the functions.
NOTE: This TV also has the option of using a Memory Pack which enables you to copy the preset TV channels into the Memory Pack and
then download them onto this or any other EURO-3 TV set.
TV to Memory Pack process
1.
Plug the memory pack into the AV2 21 pin terminal at the
back of the TV and switch the TV on.
2.
Go into the Service Mode as explained above. The screen
will show:-
3.
Press the blue button on the remote control. The screen will
show:-
4.
Press the STORE button on the TV. The screen will
5.
All the tuning information stored inside the TV will now be
transferred to the Memory Pack. This process will take 2-3
minutes to complete and when finished the screen will show:-
Memory Pack to TV Process
Errors
If an error occurs while using the Memory Pack the TV will detect this and the screen will show:-
If this happens then press the Normalisation button and repeat the process that was being used. If the errors continue to occur then check the
connectors between the TV and the memory pack and check the 9V battery inside the memory pack.
3.
Press the YELLOW / BLUE buttons to alter the function
values.
4.
Press the STORE button after each adjustment has been
made to store the required values.
5.
To exit the Service Mode press the Normalisation button..
1.
Plug the memory pack into the AV2 21 pin terminal at the
back of the TV and switch the TV on.
2.
Go into the Service Mode as explained above. The screen
will show:-
3.
Press the STORE button on the TV. The screen will
4.
All the tuning information stored inside the Memory Pack will
now be transferred to the TV. This process will take 2-3
minutes to complete and when finished the screen will show:-
show:-
5.
The tuning information from the Memory Pack has now been
copied into the TV.
6.
To exit from the Service Mode press the Normalisation
button.
7.
The process has now been completed and the Memory Pack
can now be removed.
show:-
Advertisement
Table of Contents
