Getting Started; Resetting The Unit; Performing Initial Setup; Preparing The Card Remote - Sony MEX-DV1600U Operating Instructions Manual

Getting Started

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 13) and press the
RESET button (page 9) with a pointed object,
such as a ball-point pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.

Performing initial setup

SOURCE / OFF
Control dial
After resetting, the display for initial speaker
setup appears.
Be sure to set correctly following the procedure
below to enjoy the various sound functions of
this unit.
To skip the initial setup, press (SOURCE/OFF),
or insert a disc.
12
1
Press the control dial in the initial
setup display.
2
Rotate the control dial to set the audio
output, then press it.
If a subwoofer is connected, select "SUB
OUT."
If a power amplifier is connected, select
"REAR OUT."
If neither subwoofer or power amplifier is
connected, you can select either "SUB OUT"
or "REAR OUT."
3
Rotate the control dial to select your
listening position, then press it.
Select "FRONT L" if your listening position
is front left, or select "FRONT R" if front
right.
The clock display appears when the setting is
complete.
Note
During the initial setup procedure, returning to the
previous display is not possible by pressing
restart the initial setup, reset the unit by pressing the
RESET button.
With the card remote commander
Press M/m instead of rotating the control dial, press
(ENTER) instead of pressing the control dial.

Preparing the card remote

commander

Remove the insulation film.
Tip
For how to replace the battery, see page 51.
. To