Advertisement
[ON][new PIN2][Enter]
4.3
Changing the User Code [PIN2] without the
Master Code
[ON][Enter][3][Enter]
[1-9 (user number)][Enter][PIN2][Enter]
[new PIN2][Enter]
[repeat new PIN2] [Enter]
Checking the new User Code:
[ON][new PIN2][Enter]
4.4
Deleting the User Code
[ON][Enter][0][Enter][1-9 (user
number)][Enter][PIN1][Enter]
4.5
Switching off/switching on the sound
[ON][Enter][5][Enter][PIN1][Enter]
5
Time Delay Function
5.1
Switching on the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[01-99 – delay time] [1-9 – time for
opening] [Enter]
E.g.: 092 – 9 minutes is the delay time, 2 minutes is
the time for opening
5.2
Opening the Lock with the Time Delay
[ON] [PIN1 or PIN2] [Enter] (Waiting
Delay Time. Acoustic signal will inform
about the end.)[PIN1 or PIN2] [Enter]
Pressing [Enter] during Time Delay leads to an
interruption. Operation has to be started again.
5.3
Switching off the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[000] [Enter]
Safe Digital Lock
PS310/E01, PS310/ES01, PS310/E02
6
Dual Code Function
6.1
Switching on the Dual Code function
Before switching on the function, make sure you
have assigned a User Code [PIN2] see par.4.2.
The Dual Code function has priority over other lock
functions.
[ON] [Enter] [7] [Enter] [PIN1] [Enter]
When press [ON] button, switched on Dual Code
2
function indicates [
G]
(see par.2.3).
6.2
Opening with the Dual Code function
[ON][0-9 (user number)][Enter]
[PIN2][Enter]
[0-9 (user number)][Enter]
[PIN3][Enter] – in 1 minute
The User number of Master Code is [0].
After right first Code was entering [PIN2][Enter], for
enter the second Code [PIN3][Enter] there are just 1
1
minute, that indicates [
G]
(see par.2.3) every 5
seconds.
6.3
Switching off the Dual Code function
[ON] [Enter] [8] [Enter] [PIN1] [Enter]
7
Servicing
7.1
Changing the Battery
The battery is located on the inner side of the
door. Depending on the safe model, battery
could
be
either
inside
compartment (Fig.7.1a) or in a special pull-out
battery box (Fig.7.1b).
Take out the cover of the battery compartment
of the lock (see Fig. 7.1a. or pull out the box
(see Fig. 7.1b).
www.promet-safe.com
Fig. 7.1
Install a new battery (9V, type 6LF22).
Take the cover or the box back to their location.
7.2
Take a new battery (9V, type 6LF22).
Press the new battery to emergency power pins
and fix it in this position (see Image 7.2).
Do not make the battery's contacts to the metal parts
of the lock.
Fig.7.2
Enter the valid code on the keypad (1).
Disconnect the emergency battery, open the
the
lock
battery
door and change the discharged battery, see
par. 7.1.
USER MANUAL
a.
b.
Opening the lock when the Battery is
Discharged
Ver. 1/3 15.02.2019
Advertisement
