Promet PS600/E36 User Manual

S D
AFE IGITAL
PS600/E36
USER MANUAL
1

Main Components

Fig.1.1
1 – Case
2 – Keypad
3 – Green LED [G]
4 – Red LED [R]
5 – Battery box
2

Definitions

L
2.1
OCK
A set of numbers (from 6 to 8 digits) which opens
the lock and allows to operate the settings.
Before using the safe, please change the factory
Master code (see par.4.1). It is strongly
recommended to keep the master code safe
from unauthorized people.
No easily guessed numbers (birthdays, house
and phone numbers, etc.) or simple codes (1, 2,
3, 4, 5, 6) shall be chosen for the coding.
Factory Master Code:
1–2–3–4–5–6
2.2
A set of numbers from 6 to 8 digits which opens
the lock and has limited functions to change the
settings.
The lock with default factory settings does not
have the User code. Please see par.4.2 to set
the User code.
2.3

[
green LED flash (3) – confirmation of the button
pressing on the keypad.

[
green LED flash (3) – confirmation of successfully
finished operation.

[
LED flash (4) – error message on the user's actions.

[
red LED flashes (4) – low battery message. Please see
par.5.1 how to change the battery.
Safe Digital Lock
PS600/E36
Master Code [PIN1]
User Code [PIN2]
Signals
1
G] Short single acoustic signal with single
2
G] Short double acoustic signal with double
R]-- Long single acoustic signal with single red
5
R] Short acoustic signal sounds 5 times with 5
www.promet-safe.com
USER MANUAL
3

Main Functions

3.1

Opening the Lock

3.1.1 Opening with the Factory Master code
[ON][1][2][3][4][5][6][Enter]
3.1.2 Opening with the Master Code
[ON][PIN1][Enter]
3.1.3 Opening with the User Code
[ON][PIN2][Enter]
3.1.4 Opening with the Dual Code
[ON][PIN1][Enter]
[PIN2][Enter] – in 1 minute
After right Master Code
[PIN1][Enter], for enter User Code [PIN2][Enter]
there are just 1 minute, that indicates [
par.2.3) every 5 seconds.
If the code is right, there will be a green LED
flash and it will be possible to open the door within 5
seconds by turning the door hand clockwise.
If you enter a wrong code three times in a row,
the lock will be blocked for 5 minutes. The
blocking of the lock will be indicated periodical
red LED flashes.
3.2

Closing the Lock

Close the door and turn the door hand anti-
clockwise until it stops.
4 Service Functions
It is strongly recommended to change the
settings of the lock with the door opened.
After code changing, the lock shall be tested
several times with the secure storage unit's door
in open state.
was entering
1

G] (see
Ver. 3/1 21.02.2017