Promet PS610/E36 User Manual

S D
AFE IGITAL
PS610/E36
USER MANUAL
1 Main Components
Fig.1.1
1 – Case, 2 – Keypad, 3 – Green LED [G], 4 – Red LED
[R], 5 – Battery box
2 Definitions
2.1 Master Code [PIN1]
A set of numbers (from 6 to 8 digits) which opens
the lock and allows to operate the settings.
Before using the safe, please change the factory
Master code (see par.4.1). It is strongly recommended
to keep the master code safe from unauthorized
people.
No easily guessed numbers (birthdays, house and
phone numbers, etc.) or simple codes (1, 2, 3, 4, 5, 6)
shall be chosen for the code.
L
OCK
Factory Master Code:
1–2–3–4–5–6
2.2
A set of numbers from 6 to 8 digits which opens
the lock and has limited functions to change the
settings.
The lock with default factory settings does not have
the User code. Please see par.4.2 to set the User
code.
2.3

[
green LED flash (3) – confirmation of the button
pressing on the keypad.

[
green LED flash (3) – confirmation of successfully
finished operation.

[
LED flash (4) – error message on the user's actions.

[
red LED flashes (4) – low battery message. Please see
par.7.1 how to change the battery.
3 Main Functions
3.1
3.1.1
[ON][1][2][3][4][5][6][Enter]
3.1.2
[ON][PIN1][Enter]
3.1.3
[ON][PIN2][Enter]
Safe Digital Lock
PS610/E36
User Code [PIN2]
Signals
1
G] Short single acoustic signal with single
2
G] Short double acoustic signal with double
R]-- Long single acoustic signal with single red
5
R] Short acoustic signal sounds 5 times with 5
Opening the Lock
Opening with the Factory Master code
Opening with the Master Code
Opening with the User Code
www.promet-safe.com
If the code is right, there will be a green LED
flash and it will be possible to open the door within 5
seconds by turning the door hand clockwise.
If you enter a wrong code three times in a row, the
lock will be blocked for 5 minutes. This will be
indicated via periodical red LED flashes.
3.2 Closing the Lock
Close the door and turn the door hand anti-
clockwise until it stops.
4 Service Functions
It is strongly recommended to change the settings of
the lock with the door opened.
After code changing, the lock shall be tested several
times with the secure storage unit's door in open
state.
The service functions will be unavailable in case of
low power supply which is indicated by the signals,
5
please refer to par.2.3, [R] .
4.1 Changing the Master Code [PIN1]
[ON] [Enter] [1] [Enter] [PIN1] [Enter]
[new PIN1][Enter][repeat new PIN1][Enter]
Checking the new Master code:
[ON][new PIN1][Enter]
4.2 Setting and changing the User Code [PIN2]
with the Master Code [PIN1]
Before changing the User Code [PIN2] default factory
setting of Master code [PIN1] has to be changed (see
par.4.1).
[ON] [Enter] [2] [Enter]
[1-9 (user number)] [Enter] [PIN1] [Enter]
[new PIN2] [Enter]
[repeat new PIN2] [Enter]
Checking the new User code:
Ver. 1/3 25.02.2019г.
USER MANUAL