Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Owon THS 317-ET
Summary of Contents for Owon THS 317-ET
- Page 1 ZigBee Multi-Sensor Quick Start Guide...
-
Page 2: Safety Handling
Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the ZigBee Multi-Sensor and other property. Read all the safety notices below before using the ZigBee Multi-Sensor. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light. -
Page 3: Technical Specifications
Technical Specifications Wireless Connectivity ZigBee • 2.4GHz IEEE 802.15.4 • ZigBee 3.0 ZigBee Profile • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m RF Characteristics / 30m (Open area) • Internal PCB Antenna Physical Specifications Battery • DC 3V (Two AAA batteries) • 2-color LED (Red,Green) • Temperature: -10℃ ~+55℃ Operating environment • Humidity: ≤... - Page 4 • Distance: 5m • Angle: Detecting range(PIR) up/down 100° left/right 120° • 62(L) × 62 (W)× 15.5(H) mm • Line length of remote probe: Dimensions External temperature: 2.5m (Optinal) • Ta b l e t o p s t a n d o r W a l l Mounting Type mounting...
- Page 5 Welcome The Multi-sensor is used to measure the ambient temperature & humidity with built-in sensor and external temperature with remote probe. It is available to detect motion, vibration and allows you to receive notifications from mobile app. The above functions can be customized, please use this guide according to your customized functions.
-
Page 6: Installation
Features: • ZigBee 3.0 • PIR motion detection (Optional) • Vibration detection (Optional) • Environmental temperature & humidity measuring (Optional) • External temperature probe(Optional): Available for water measurement • Low power consumption Installation You can mount the multi-sensor to the wall, ceiling or keep your multi-sensor on a bookshelf or table. - Page 7 1. Avoid mounting the Multi-sensor close to pets, air conditioners, heaters, sunshine or places where the temperature varies. 2. You need to pay attention to the distance and range of the sensor when installing. 100˚ 120˚ 2.1m...
- Page 8 External temperature probe: Please refer to the mounting example below. You can measure the temperature by touching the probe with the measured object. Such as water, floor, metal etc. But don't put it in the environment with strong acid and alkali...
-
Page 9: Get To Know Your Device
Get to know your device LED indicator Reset button LED indicator The LED status gives the following information: LED status What it means Red LED flashes once Motion detected When you press the reset button once Flashing green Device has joined a ZigBee network. -
Page 10: Configure Network
Reset button Reset: Press and hold the reset button for 10 seconds until the LED light flashes three times at third second, and it will flash for three times again at tenth second. Configure Network 4.1 To get started, you will need: •... - Page 11 to factory defaults). 3. Make sure the Multi-sensor is in the range of gateway's network. After few seconds the Multi-sensor will join the gateway automatically and the LED indicator will flash green when it successfully joined. Note: If the adding is failed, simply reset the Multi-sensor and retry.
Need help?
Do you have a question about the THS 317-ET and is the answer not in the manual?
Questions and answers