Activating And De-Activating The Radio Communication; Recording The Thickness Measurements - 493K K-METRON User Instructions

K-METRON Radio User Instructions (Firmware 3.0.4; Doc v4.0)
When the K-METRON is not recording the Status is displayed as Stopped.
If when the Start button is clicked a warning appears to say "Cannot connect to K-Products"
then check to ensure that the receiver is connected and that the correct COM port is
selected.

8.5 Activating and De-activating the Radio Communication.

The K-METRON Handheld Radio Module can be activated or de-activated. This is set within
the Configuration menu under the section "Radio". The battery life will be improved when
the radio is de-activated and the unit will not show a Tx Error on pulling the orange trigger
when the receiver is not connected.

8.6 Recording the Thickness Measurements.

Hit the start button to begin receiving and recording data transmitted from the handheld K-
METRON. Received data will be presented on a line per line basis and will record Date, Time,
Mould ID, Position number and Reading.
21 | P a g e