Deleting A Thickness Measurement; Indexing Mould Id; Units Of Measurement - 493K K-METRON User Instructions

7.2 Deleting a Thickness Measurement.

If an erroneous thickness measurement has been made and transmitted to the PC then it
can be remotely deleted from the PC. To do this press the X (or "Delete") button; the display
signals confirmation. The Position Number on the PC will then be reduced by '1'.

7.3 Indexing Mould ID.

After the thickness measurements on a particular mould are completed the user has the
option to increment the Mould Identification number. This number is used as a guide to
indicate which moulds are being measured and recorded.
To increment the Mould Index number, complete the following two steps:
Step 1. Move the magnet away from the sensor head so that O/R ('out of range') is
displayed on-screen;
Step 2: Hold the trigger down for 7 seconds.
The on-screen indication will now show that the Mould Index number has been
incremented.

7.4 Units of Measurement

Measurements can be made using IMPERIAL or METRIC units. Units are changed in the
Configuration Menu under the "Units" section. To enter the Configuration Menu:
1. Hold down the X button (or "Delete" button in older models) and switch the unit on
by pressing the On/Off button.
2. Continue to hold down the X (or "Delete") button, the display will read "Wait ...
Setup mode".
3. Continue holding down until the display reads "MAG TYPE" then release the X (or
"Delete") button. (Ensure that the orange trigger is not being mistakenly held down).
4. Once the display reads "MAG TYPE", the unit is now in the Configuration Menu.
The Configuration Menu is navigated using the following buttons:
To SCROLL through the Menus press X (or "Delete").
To SELECT a Menu item, press the ORANGE TRIGGER.
Scroll through the menu section and select the "Units"; then scroll through
METRIC/IMPERIAL/EXIT and select the desired Units. The unit will now exit the configuration
menu and return to operational status ready to measure using the units of measurement
chosen.
17 | P a g e
K-METRON Radio User Instructions (Firmware 3.0.4; Doc v4.0)