Creating A New Group; Create Function - Sony CMT-M333NT Operating Instructions Manual

Creating a new group

— Create Function

The Create Function allows you to create a new
group without registering any tracks, or to create
a new group and register one or more
consecutive tracks into that group. Only tracks
that have not yet been registered into any group
can be registered.
For details on the Group Function, see
"Registering tracks in groups" on page 23.
1
Press FUNCTION repeatedly to switch
the function to MD.
2
Press GROUP repeatedly until
"GROUP" appears.
3
Press MENU/NO.
4
Press . or > repeatedly until "Gp
Create?" appears, then press ENTER/
YES.
5
Perform steps 3 to 6 of "Labeling an
MD/group/track" (page 25).
6
Press . or > repeatedly until
"Assign None" appears, then press
ENTER/YES.
Note
When creating a group without registering any tracks,
you must enter the group title.
To register tracks into a group
In step 6, press . or > repeatedly to
select the number of the first track you
want to register, then press ENTER/YES.
When registering only one track, press ENTER/
YES again.
When registering two or more tracks, press .
or > repeatedly to select the number of the
last track you want to register, then press
ENTER/YES.
Notes
• You cannot register the same track to more than one
group.
• If you do not enter a group title in step 5, "Group **
(group number)" appears as the group title.
Tip
You can also register tracks that were recorded on a
system that does not support the Group Function.
GB
27