Zte MC7010 Quick Start Manual page 13

Detecting and Adjusting Installation Position
1. Move the device around the mounting wall/pole or try different positions and
touch DETECT POSITION.
2. Follow the on-screen instructions to attach the device to your target position,
and slowly move it until it provides feedback.
NOTE:
The device does not support elevation angle adjustment. It only supports horizontal
180° adjustment.
3. The signal strength at the current position is displayed (Perfect, Great, Good,
Poor and Terrible). You can touch view details to view the network details.
When the device signal is detected, your phone automatically beeps. The louder
the sound and the stronger the vibration, the better the signal strength.
NOTE:
Touch FINISH to end the detection and select whether to save the current position
if needed.
4. Continue the detection until the desired position is detected, and save or
continue to adjust the position as prompted.
Powering off the MC7010
After the installation position is determined, disconnect the POE adapter from the
device.
10