Table of Contents
Advertisement
9.
Lock the front panel in place by securing it with the screws.
2.2.2
Wall Mounting
The wall mounting option provides protection from shock and vibration when in
operation.
Note!
When installing, make sure to allow for enough space to properly install
the cabling.
To wall mount the device
1.
Locate the mounting brackets and position them on the sides of the device.
2.
Secure the brackets to the device with the provided screws.
3.
On the installation site, place the device firmly against the wall. Make sure the
device is vertically and horizontally level.
4.
Insert a pencil or pen through the screw holes on the mounting brackets to mark
the location of the screw holes on the wall.
5.
Remove the device from the wall and drill holes over each marked location (4)
on the wall. If installing on a wooden surface, keeping in mind that the holes
must accommodate wall sinks in addition to the screws.
If necessary, insert the wall sinks into the drilled screw holes.
6.
Insert the mounting screws on the drilled locations and tighten halfway. Do not
tighten complete or the bracket cannot be installed properly.
Figure 2.11 Securing a Front Panel
12
EKI-9502G Series User Manual
Advertisement
Table of Contents
