Maintenance; Troubleshooting - DeLonghi HMP Series Instructions For Use Manual

temperature at about 41°F (5°C), preventing freezing with
minimal energy consumption.

MAINTENANCE

Before carrying out any maintenance, unplug the heater from
the mains and wait for it to cool off completely. This heater
requires no particular maintenance. It is sufficient to remove
the dustwith a soft, dry cloth. Never use abrasive powders or
solvents. If necessary remove concentrated areas of dirt with
a vacuum cleaner.

TROUBLESHOOTING

PROBLEM
The appliance doesn't work
The alarm sound and the ap-
pliance doesn't work
CAUSE
Be sure it is plugged in and that the electri-
cal outlet is working.
The power selector is in the OFF position.
The thermostat may be set too low.
The tip-over switch has been activated.
Check for any obstruction.
Plug into the outlet.
Turn the power selector to the position MIN,
MAX.
Turn the thermostat clockwise to a higher
setting until the heater restarts.
Make sure the appliance is standing upright
on a flat surface, if the problem persist, con-
tact the De longhi toll free number.
Remove the obstruction, unplug the heater
and let the appliance cool down. If the ap-
pliance doesn't work please contact the De
longhi toll free number.
7
SOLUTION