Removing The Tpu Cr Motor - Epson Perfection V500 Photo Service Manual

EPSON Perfection V500 Photo

4.2.17 Removing the TPU CR Motor

When performing the procedure given below, be careful not to lose
C A U T I O N
the three torsion springs that apply tension to the TPU CR Timing
Belt.
1. Remove the Hinge Assy.s. See Section 4.2.12 on page 44.
2. Remove the TPU Carriage Unit.
3. Disconnect the TPU CR Motor Connector CN2 from the DRV Board.
4. Remove the acetate tape and release the CN2 Connector Cable from the notch and
tabs shown in Figure 4-46.
TPU CR Motor Unit
Figure 4-46. Removing the TPU CR Motor Connector
DISASSEMBLY / ASSEMBLY
See Section 4.2.15 on page 46.
DRV Board
CN2
Tabs
Notch
Acetate Tape
5. Remove the three C.P.F.P. M3 x 8 screws that secure the TPU CR Motor Unit and
remove it.
(4.5±0.5kgf.cm)
Figure 4-47. Removing the TPU CR Motor Unit (1)
6. Remove the TPU CR Timing Belt from the TPU Driven Pulley and remove the
TPU CR Motor Unit.
Figure 4-48. Removing the TPU CR Motor Unit (2)
Disassembly Procedure
C.P.F.P. 3 x 8
TPU Driven Pulley
TPU CR Timing
Revision A
50