Recording To The Hdd - Sony HAR-D1000 Operating Instructions Manual

8
Press MENU/NO.
9
Press CD SYNC.
When "Sync Normal" was selected,
"CD SYNCHRO – Normal –" appears in
the display.
When "Sync High" was selected,
"CD SYNCHRO – High –" appears in the
display.
The HDD stands by for recording and the
CD stands by for playback.
To change the album position, turn
ALBUM dial (or press ALBUM +/– on the
remote repeatedly). When using the remote,
press ALBUM and the numeric button(s) to
enter the position directly (see page 19).
10
After "CD SYNCHRO – Normal –" (or
"CD SYNCHRO – High –") disappears,
press HDD H or HDD X.
Recording starts.
Track playback is not audible during high-
speed Synchro-Recording.
To stop recording
Press CD x or HDD x.
Tips
• You can use Program Play to specify only the CD
tracks you want to record. After loading a CD, do
the procedure of "Programming the CD tracks" on
page 11. Then do the Synchro-Recording
procedure afterwards.
• If you set "TxtSave" to "On" in the setup menu, CD
text (track name only) can be saved to the HDD
automatically.
• Synchro-Recording enables the assignment of
album and track names from the CDDB2. For
details on the CDDB2, refer to the Help for
"M-crew for HAR-D1000".
Notes
• If the HDD becomes full during recording,
recording ends automatically.
• You cannot pause recording during Synchro-
Recording.
• If the CD play mode is set to Repeat Play or Shuffle
Play, it automatically switches to Normal Play.
• The HDD play mode automatically switches to
Normal Play.
• Sound input automatically switches to "CD" during
Synchro-Recording.
• The recording level changes to 0.0 dB
automatically during CD-HDD Synchro Recording
no matter what the setting in the setup menu is.
• CD text may not be saved for short tracks.
If "Retry" flashes in the display after
you press the CD SYNC button
A reading failure has occurred, and the recorder
is trying to read the data again.
• If the retry was successful, the recorder
continues with High-Speed CD-HDD
Synchro-Recording.
• If the condition of the loaded CD or the
system is poor, and retry fails, High-Speed
CD-HDD Synchro-Recording is disabled. In
this case, " 2" flashes in the display and the
recorder automatically starts recording in
normal CD-HDD Synchro-Recording. Note
that monitoring of the recorded signal is not
possible when this occurs.

Recording to the HDD

When using the remote, set SELECT to HDD.
1
Turn on the amplifier and set the
source selector to the position for this
recorder.
2
Press @/1 to turn on the recorder.
The STANDBY indicator turns off.
3
Press INPUT repeatedly to select the
sound source
Sound source
The CD in the recorder
The component
connected to the
DIGITAL OPTICAL
IN connector
The component
connected to the
ANALOG IN jacks
Select
CD.
OPT.
ANLG.
continued
13