Getting Started; Inserting Batteries Into The Remote; Hooking Up The System - Sony HAR-D1000 Operating Instructions Manual

Getting Started

Inserting batteries into
the remote
You can control the recorder using the supplied
remote.
Insert two R6 (size AA) batteries by matching
the + and – on the batteries to the diagram
inside the battery compartment.
Insert the negative (–) end first, then push in
and down until the positive (+) end clicks into
position. When using the remote, point it at the
remote sensor on the recorder.
Tip
When the remote no longer operates the recorder,
replace both batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or
humid place.
• Do not drop any foreign object into the remote
casing, particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.

Hooking up the system

Hookups
This section describes how to hook up the
HDD recorder to an amplifier. Be sure to turn
off each component before making the
connections.
ANALOG DIGITAL CD CHANGER USB
CONTROL
IN OUT OPTICAL
IN
L
R
ANALOG
OUT
(White) (L)
ANALOG
OUT
(Red) (R)
Audio input
(White) (L)
: Signal flow
Making digital hookups
If you have a digital component such as a
digital amplifier, D/A converter, DAT, or MD,
connect the component via the DIGITAL
OPTICAL IN connector using the optical cable
(not supplied). Take off the cap and plug in the
optical cable.
Be sure not to bend or tie the optical cable.
POC-15
Optical cable (not supplied)
HDD recorder
DIGITAL
OPTICAL
IN
HDD recorder
To a wall outlet
Audio input
(Red) (R)
Amplifier
To a wall outlet
Digital component
DIGITAL
OUTPUT
OPTICAL
continued
7