General Description; Design; Led-Signals For Channels; Led-Signals For Operation - SAFEMATIC MAXILUBE IF-105 Manual

USER INTERFACE IF-105

1 GENERAL DESCRIPTION

IF-105 is a user interface for MaxiLube lubrication system.
Lubrication programming, alarm resetting and lubrication event monitoring can be performed
with the user interface.

2 DESIGN

Note
The IF-105 user interface includes a display (pos.1), LED-signals for lubrication lines and
pressurization (pos.2), browsing buttons (pos.3), a setting/function button (SET) (pos.4) and
LED-signals for lubrication channels (pos.5).

2.1 LED-signals for channels

Note
LED-signal
CH1
CH2

2.2 LED-signals for operation

Note
LED-signal
L1
L2
P
MUIF3AEN.doc
Numbers in brackets are part numbers of drawing 461981A.
LED-signals CH1 and CH2 for lubrication channels are in use only in
systems with two channels.
Description
Red LED-signal is lit, when channel 1 is in alarm mode.
Green LED-signal is lit, when channel 1 is not in alarm mode.
LED-signal is blinking when channel 1 is selected on the display.
Red LED-signal is lit, when channel 2 is in alarm mode.
Green LED-signal is lit, when channel 2 is not in alarm mode.
LED-signal is blinking when channel 2 is selected on the display.
LED-signals indicate the operation of the channel which is selected on the
display.
Description
Green LED-signal is lit, when main line 1 is pressurized.
Green LED-signal is lit during interval, when main line 1 has been pressurized
last.
Red LED-signal is blinking, when main line 1 is in pressure alarm mode.
Green LED-signal is lit, when main line 2 is pressurized.
Green LED-signal is lit during interval, when main line 2 has been pressurized
last.
Red LED-signal is blinking, when main line 2 is in pressure alarm mode.
Green LED-signal is lit, when pressurization phase is in progress.
Red LED-signal is blinking, when the pumping center is in low level alarm
mode.
MAXILUBE
IF-105
1 (9)
21.4.2005 Rev. 3A