MULTIQUIP WHITEMAN PRX Operation Manual page 12

ENVIRONMENTAL SAFETY/DECOMMISSIONING
NOTICE
Decommissioning is a controlled process used to safely
retire a piece of equipment that is no longer serviceable.
If the equipment poses an unacceptable and unrepairable
safety risk due to wear or damage or is no longer cost
effective to maintain (beyond life-cycle reliability) and is to
be decommissioned (demolition and dismantlement), be
sure to follow the rules below.
„ NEVER pour waste or oil directly onto the ground, down
a drain, or into any water source.
„ Contact your country's Department of
Public Works or a recycling agency in your
area and arrange for proper disposal of
any electrical components, waste, or oil
associated with this equipment.
„ When the life cycle of this equipment is over, remove
the battery and bring it to an appropriate facility for lead
reclamation. Use safety precautions when handling
batteries that contain sulfuric acid.
„ When the life cycle of this equipment is over, it is
recommended that the frame and all other metal parts
be sent to a recycling center.
Metal recycling involves the collection of metal from
discarded products and its transformation into raw
materials to use in the manufacturing of new products.
Recyclers and manufacturers alike promote the process
of recycling metal. Using a metal recycling center
promotes energy cost savings.
PAGE 12 — PRX RIDE-ON POWER FLOAT • OPERATION MANUAL — REV. #1 (01/05/21)
SAFETY INFORMATION
EMISSIONS INFORMATION (GASOLINE)
NOTICE
The engine used in this equipment is a dual fuel engine
(gasoline/LPG). The gasoline side of the engine has been
designed to reduce harmful levels of carbon monoxide
(CO), hydrocarbons (HC) and nitrogen oxides (NOx)
contained in gasoline exhaust emissions.
This engine has been certifi ed to meet US EPA evaporative
emissions requirements in the installed confi guration.
Attemps to modify or make adjustments to the engine
emission system by unauthorized personnel without proper
training could damage the equipment or create an unsafe
condition.
Additionally, modifying the fuel system may adversely affect
evaporative emissions, resulting in fi nes or other penalties.
EMISSIONS INFORMATION (LPG)
NOTICE
The LPG (propane) side of the engine used in this
equipment uses components that meet US EPA Phase 3
and CARB Large Spark Ignited (LSI) emission regulations.
Any modifi cations to the fuel system or any adjustments
made to the engine will cause the engine to be in
non-compliance with emission regulations.
Emission Control Label
The emission control label is an integral part of the emission
system and is strictly regulated.
The label must remain with the engine for its entire life.
If a replacement emission label is needed, please contact
your authorized engine distributor.