Plantronics POLYCOM Voyager Focus 2 Office User Manual page 6

NOTE
Use this setup if you are not using the HL10 lifter or EHS cable. In this configuration, press
both the headset button on your desk phone and the call control button on the headset to
answer or end calls.
B Desk phone (standard)
• Connect one end of the telephone interface cable to the back of the base
• Disconnect the handset coil cord from the base of the desk phone and re-connect it to the
telephone interface cable junction box
• Finally connect the remaining end of the telephone interface cable into the open handset port
on the desk phone
IMPORTANT
Cisco phones use configuration
default configuration A.
NOTE
Use this setup if you are not using the HL10 lifter or EHS cable and your desk phone does
not have a dedicated headset port. In this configuration, manually remove the handset on your
desk phone and press the call control button on the headset to answer or end calls.
C Desk phone + EHS cable (sold separately)
IMPORTANT
Use configuration
including Cisco phones.
D Desk phone + HL10 lifter (sold separately)
USE
D on the bottom of the base. Most other phones use
USE
A on the bottom of the base, which works for most phones
6