Advertisement
12 Volt Power Adapter Harness Installation: for '07-'10 JK
FIG3
Remove the two upper screws using a
7mm socket. (FIG 3) Using a trim clip
removal tool gently remove the lower
FIG5
Remove the two lower screws using a
7mm socket. (FIG 5)
FIG7
FIG4
dash panel starting at the top. (FIG 4)
There are clips at the top and then it
will lift upward and out.
FIG6
Gently pull the center panel away from
the dash to release the clips and tilt
it enough to access the 12 volt socket
connection. Squeeze the white tab and
disconnect it. (FIG 6)
Connect the white connector on the
new wiring harness to the original plug
you just disconnected in FIG 6. Connect
the gray connector back into the 12 volt
socket. (FIG 7)
4
Advertisement
