Advertisement
Quick Links
Quadratec
®
12V Power Adapter
Installation Manual for 1997 - Current
Wrangler TJ, JK, JL & JT Gladiator Vehicles
#96080.9804
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING
TO INSTALL OR USE THIS PRODUCT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALL
TIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.
DO NOT USE IF DAMAGED.
WHEN ROUTNG ELECTRICAL WIRES, ALWAYS AVOID
PINCHING WIRES. ALWAYS AVOID HOT OR MOVING
COMPONENTS. ALWAYS SECURE WIRES WITH CABLE TIES.
Advertisement
Summary of Contents for Quadratec 96080.9804
- Page 1 12V Power Adapter Installation Manual for 1997 - Current Wrangler TJ, JK, JL & JT Gladiator Vehicles #96080.9804 TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
-
Page 2: Before You Begin Installation
Before You Begin Installation: parts are included and not damaged due Congratulations on your purchase of the to shipping. If any part is missing or Quadratec 12 Volt Power Adapter for broken, please call Customer Service your Jeep ® Wrangler. -
Page 3: Parts List
Quadratec 12 Volt Power Adapter Harness Parts & Tools: PARTS LIST: REQUIRED TOOLS: A) Power Tap Harness QTY 1 Safety Glasses Forked Clip/Trim Removal Tool Ratchet 7mm Socket Phillips Screwdriver For ’97-’06 TJ Wrangler: Put on safety glasses. Gain access to the... - Page 4 12 Volt Power Adapter Harness Installation: for '07-'10 JK FIG3 FIG4 Remove the two upper screws using a dash panel starting at the top. (FIG 4) 7mm socket. (FIG 3) Using a trim clip There are clips at the top and then it removal tool gently remove the lower will lift upward and out.
- Page 5 12 Volt Power Adapter Harness Installation: for '11-'18 JK FIG8 FIG9 Under the steering column remove the Remove the two screws using a 7mm center panel by pulling it away from the socket. (FIG9) dash releasing the clips. (FIG8) FIG10 FIG11 Using a trim clip removal tool gently On the window control switch...
- Page 6 12 Volt Power Adapter Harness Installation: for '11-'18 JK FIG13A FIG14 FIG13 Next, lift the large dash top panel off On top of the dash lift up the rubber tray insert and remove the screw using carefully set aside (as highlighted in FIG 13A).
- Page 7 12 Volt Power Adapter Harness Installation: for '18-'Current JL & JT Gladiator FIG17 FIG18 Put on safety glasses. Using a trim clip Disconnect any wiring harnesses and set removal tool gently remove the center control panel aside. (FIG 18) dash control center (FIG 17) FIG19 FIG20 Remove the center screw using a Phillips...
- Page 8 RGA number (610-701-3336). All labor, warrants to the initial retail purchaser only removal, shipping and installation costs are that your Quadratec accessory shall be free of customer’s responsibility. defects in material and workmanship: for a period of three (3) years from date of retail Other Limitations - Exclusion of Damages - purch ase.