Advertisement
LINE VOLTAGE SELECTION
START/STOP
ASSEMBLY
1. Remove the main unit with the packing from the box
and take off the packing.
2. Set the 45-rpm adaptor on the main unit.
3. Insert the turntable platter onto the center spindle
and then stretch the belt around the pulley through
the opening on top of the platter.
4. Set the slip mat on the platter.
5. Installation of cartridge:
When installing a cartridge, refer to the operating
instructions of that cartridge.
During installation, attach the stylus protector to
guard the stylus tip from damage.
(1) Connect the lead wires to the cartridge terminals.
The terminals of most cartridges are color coded.
Connect each lead wire to the terminal of the
same color.
White
(L+) ................... Left channel+
Blue
(L-) ..................... Left channel-
Red
(R+) ........................ Right c hannel+
Green
(R-) .................. Right channel-
(2) Install the cartridge to the headshell and tighten
it with screws provided with the cartridge.
6.
Insert the headshell into the front end of the
tonearm, then turn the lock nut clockwise with the
headshell firmly held horizontally.
PLACEMENT
Ÿ Do not place the unit in a location where it will be
exposed to direct sunlight or near a heating appliance.
Ÿ Do not place the unit in a location where there is high
humidity or a lot of dust.
Ÿ Cartridge may pick up slight sound pressures or
vibrations from the speakers coming along the floor or
* The desired voltage may be
set with the VOLTAGE
SELECTOR switch on the
cabinet, using a screwdriver.
* Do not twist the VOLTAGE SELECTOR switch with
excessive force as this may cause damage.
* If the VOLTAGE SELECTOR switch does not move
smoothly, please contact a qualified service center.
7.
Slide counterweight onto tonearm.
Twist it lightly and it will screw onto the rear shaft
of the tonearm.
8.
Adjustment of horizontal zero (0) balance and
stylus pressure:
(a) Remove the stylus protector, do not touch the
stylus tip during the adjustment.
(b) Release the arm clamp and lift the tonearm from
the arm rest to free it.
(c) Rotate the counterweight until the tonearm is
approximately balanced horizontally (floats
freely).
(d) Refasten the tonearm with the arm clamp.
(e) Hold the counterweight stationary with one
hand and rotate only the stylus-pressure ring
to bring the number "0" of the ring into
alignment with the center line on the tonearm
rear shaft.
(f) Rotate the counterweight clockwise until the
scale shows the value corresponding to the
pressure of the used stylus. The stylus
pressure of the installed pick-up system is 2-5
g. It you use a separate pick-up system, please
follow the manufacturer's instructions.
9.
Install the dust cover to the main unit.
through the air resulting in howling. Find a location
which is very stable and vibration free.
Ÿ The legs have functions for adjusting the height of
the unit itself. Adjust the legs to stabilize the main
body horizontally.
Advertisement
