Advertisement
CONNECTIONS
1. Connect the power cord to the auxiliary power outlet
on the rear panel of your amplifier or receiver or to a
household AC outlet.
2. Connect the unit output terminals to the PHONO jack
of your amplifier or receiver.
Output terminals
L (White)
OPERATION
1. Push the power button to turn on the power, the
speed indicator and the strobe-illuminator will light
up.
2. Place a record on the slip mat, when playing a 45rpm
record with a large center hole. Place the 45-rpm
adaptor on the center spindle.
3.
Set the speed to match with the record.
4. Remove the stylus protector, release the arm clamp.
5. Press the Start/Stop button, the turntable platter will
start to rotate.
6. Move the tonearm to the desired groove and play
begins.
7. When play is finished, move the tonearm to the arm
REMOTE CONTROL START/STOP
For the disco operation, the s tart/stop function can
remotely be controlled by a separate switch, via a mixing
console with so-called fader start. If at the mixing
MAINTENANCE
• Clean the stylus periodically with a soft brush to
prevent the accumulation of dust.
• When the sound becomes distorted or noisy, check
the stylus. If worn out, replace it with a new one.
• From time to time,the dust cover and turntable cabinet
SPECIFICATIONS
*General
Power supply.....................AC 115/230V, 50/60Hz
Power consumption.........................................10 Watts
For improvement purposes, specifications and design may be changed without notice.
Amplifier(Receiver)
L
CH
R (Red)
GND (Spade)
NOTE:
Be sure to connect the ground terminal firmly to the
amplifier or receiver.
If this connection is not made or is loose, a power
source "HUM" will result.
rest, secure the tonearm with the arm clamp.
8.
Press the Start/Stop button to stop the platter
rotating, push the power button to turn off the
power.
Target light
This unit is provided with a target light for illumination
the stylus tip during play.
Push the target light will be raised into position to
illuminate the stylus tip. When not in use, keep the
target light lowered by pressing on it.
console the fader for the turntable is opened,the
turntable automatically starts responding.
Stops again if the fader is closed.
should be wiped with a soft and dry cloth.
• Any volatile materials such as alcohol, thinner,
benzine, etc., may remove the paint or damage the
lustre, please avoid.
Dimension(WxDxH).................450 x 352 x 148.5 m m
Weight..............................................................8.6 Kgs
R
CH
GND
Advertisement
