Advertisement
https://appliancetechmanuals.com
Front Installation
Some models are shipped in a removable sleeve, please add the supplied seal to the
bottom front rail as show n (to the left) before installing unit in the sleeve. Use the
follow ing instruction for installing the decorative front and accessories.
Installing the Vent Control
The vent control handle is included in the decorative front kit. The handle must be
installed before the decorative front is attached.
1. Insert the handle w ith the " etchings (Vent/Air)" facing to the left.
2. Slip the black door extension into the split at the end of the handle.
3. For ease of assembly, push the handle in w hile pressing the door extension
against the foam until the tw o pieces lock together.
4. M ove handle in and out to be sure vent is operating properly.
Installing the Front Frame
Some models require installation of the front panel of the air conditioner included
in a decorative kit. To assemble, follow these steps. Before installation, remove the
tilt panel from the frame. Grasping the panel from both sides, gently pull to release,
then lift panel from pivot points at bottom of frame).
S S T T E E P P 1 1 : : I I N N S S T T A A L L L L D D E E C C O O R R A A T T I I V V E E F F R R O O N N T T T T O O C C A A B B I I N N E E T T : :
Decorative Front
• Position the top of the decorative front over the top flange of the case, and
align the tabs w ith the slots in the case (Fig. 1).
• As you install the front frame to the unit be sure the vent handle is positioned
through the front in the proper location.
• Carefully pull dow n on the front to engage the top tabs, w hile pushing the
front over the case to ensure proper alignment.
• The side tabs w ill " click" w hen front is seated.
• Then add filter and front panel.
4
(on some models)
FIG. 1
Advertisement
