Advertisement
Using multiple Matrox Altiz units
AltiZ 2-n
The acquisition for Matrox AltiZ units that follow the first AltiZ in the sequence are triggered differently,
depending on the type of configuration (star or daisy) and the unit's position in the configuration:
- Navigate to Trigger Control under Quick Setup Control, and set Trigger Selector
(TriggerSelector) to Line Start.
- Expand Trigger Selector and set Trigger Source (TriggerSource) and Trigger
Activation (TriggerActivation) with the values from the following table :
Configuration
AltiZ 2, 4...
Trigger Source :Timer 0 End
Trigger Activation: Rising Edge
AltiZ 3, 5...
Trigger Source : Line 0
Trigger Activation: Rising Edge
Set Exposure Time
To configure Exposure Time perform the following
- Under Acquisition Control, expand Source Selector and select Source 0 (Primary). Ensure that
the value in the Exposure Time field is less than half of the value of the Acquisition Line
Period field in the case of an overlap between the Field of Views.
Application Note
Preliminary
December 7, 2020
Star
for every AltiZ in the configuration
Page 6 of 8
Daisy Chain
Trigger Source : Line 0
Trigger Activation: Falling Edge
:
Advertisement
