Installation Steps; Jumper Settings; System Memory (Dram); Central Processing Unit (Cpu) - MCi 771AS User Manual

2-4 Installation Steps

Before using your computer, you must follow the steps as follows:
1. Set Jumpers on the Motherboard
2. Install the CPU
3. Install DRAM Modules
4. Install Expansion card
5. Connect Cables, Wires, and Power Supply

2-5 Jumper Settings

1. CPU Bus Frequency : This motherboard auto-detected the processor speed. You only
need insert the AMD Athlon processor into Slot.
2. CMOS RAM Clear: JBAT (Yellow color selector)
WARNING: Make sure your computer is POWER OFF when you CLEAR CMOS.
Connect a jumper Cap over this jumper for a few seconds, will clears information stored in
the CMOS RAM Chip that input by user, such as hard disk information and passwords.
After CLEAR CMOS, you must enter the BIOS setup (by holding down <DEL> during
power-up) to re-enter BIOS information (see BIOS SETUP).
Selections
Normal
Clear CMOS

2-6 System Memory (DRAM)

This main board supports three 168-pins DIMM modules to the Max Memory Size of 1.5GB.
168-pin DIMM
168-pin DIMM 168-pin DIMM
168-pin DIMM 168-pin DIMM 168-pin DIMM

2-7 Central Processing Unit (CPU)

JBAT
1-2 (Default)
2-3 (momentarily)
DIMM 1 DIMM 2

System can be
DIMM 3
Accept or Not
X Accept
Accept
X
Accept
6