Table of Contents
Advertisement
first.
The choice: PCI Slot, AGP.
Onboard FDC Controller: Select Enabled if your system has a floppy disk controller
(FDC) installed on the system board and you wish to use it. If you install and-in FDC or the
system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2: Select an address and corresponding interrupt for the first
and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
OnChip Sound:Support Onboard Audio function.
The choice:Auto;Disable.
Sound Function:This function only active when OnChip Sound is set to Auto.
3-5 POWER MANAGEMENT SETUP
The Power Management Setup allows you to configure you system to most effectively save energy while
operating in a manner consistent with your own style of computer use.
CMOS Setup Utility – Copyright © 1984 – 1999 Award Software
ACPI function
Power Management
ACPI Suspend Type
PM Control by APM
Video Off Option
Video Off Method
MODEM Use IRQ
Soft-off by PWRBTN
Wake Up Events
Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults
ACPI Function: This item allows you to enable/disable the Advanced Configuration
and Power Management (ACPI).
The choice: Enabled, Disabled.
Power Management: This category allows you to select the type (or degree) of power
saving and is directly related to the following modes:
1. HDD Power Down
2. Doze Mode
3. Suspend Mode
There are four selections for Power Management, three of which have fixed mode settings.
Disable (default)
Min. Power Saving
Power Management Setup
Enabled
Press Enter
S1(POS)
Yes
Suspend -> Off
V/H SYNC+Blank
3
Instant-off
Press Enter
No power management. Disables all four modes
Minimum power management. Doze Mode = 1 hr. Standby Mode =
1 hr., Suspend Mode = 1 hr., and HDD Power Down = 15 min.
Menu Level
F7:Optimized Defaults
Figure 3-5
20
Item Help
Advertisement
Table of Contents
