Technical Data; Maintenance - Kayoba 011271 Operating Instructions Manual

EN
Do not exceed the maximum
load of 77 kg.
77kg
170lbs
When in use the rope must be
15-19 m long, and withstand a
load of at least 680 kg.
Max number of persons 1.
1

TECHNICAL DATA

Size
Hole diameter
Max number of persons
Material
Max load
USE
INFLATION
1. Inflate the product to approx. 25%.
2. Fit the product correctly in the cover.
Now fill to 85%.
3. In strong sunlight or warm weather take
into consideration the expansion of
the air. Only fill to 85% of the nominal
pressure, leave the product in the sun for
a few minutes, and then check the rigidity
of the product.
NOTE:
Double acting low pressure pump (1 bar),
equivalent foot pump or electric pump for
inflatable rubber boats recommended.
Pumps for higher pressure (compressors
etc.) can be used with due caution – there
is a considerable risk of overinflating and
damaging the product when using high
pressure pumps.
18
WARNING!
Do not overinflate! Too much pressure can
permanently damage the product.
TOW LINE
•
•
•
Ø 125 cm
Ø 40 cm
1
NOTE:
Vinyl
•
77 kg
•
•
•
Fastening the tow line
The line MUST be fastened correctly to work as
intended.
1.
2.
3.
FIG. 1

MAINTENANCE

REPAIRS
Small punctures and tears can be repaired with
the supplied repair kit.
The line must be fastened correctly to
work as intended.
The eyelet on the end of the line must be
threaded through the hole before it is
fastened round the hooks on the plastic
attachment.
Check the plastic attachment before use.
Do not use it if it shows signs of cracking,
fracture or other damage.
Only use a tow line intended for float
tubes!
The tow line must be fitted with a
quick-coupling.
The length of the tow line must be 15–19 m.
The minimum tensile strength of the tow
line is 680 kg.
Thread the eyelet on the end of the
line through the hole in the plastic
attachment.
Fasten the eyelet in the hooks on the
plastic attachment.
Tighten.