Contec SH-8008F Setup Manual

8 port 10/100M Unmanaged
Industrial Switching HUB
SH-8008F Setup Guide
CONTEC CO., LTD.
SH-8008F is a compact-sized industrial switching HUB unit that is compliant with the IEEE802.3u (100BASE-
TX)/IEEE802.3 (10BASE-T) standards.
Product configuration list
- Main Unit (SH-8008F) ...1 - Setup Guide (English) ...1
- Power Supply Connector...2 - Warranty certificate...1
- Serial Number Label...1
Power Supply Connector
Main Unit
Warranty
Certificate
XXXXXXXXXXXXX
XXXXXXXXXXXXX
Warranty Certificate Serial Number Label
Latest product information
CONTEC provides up-to-date information on products.
CONTEC also provides product manuals and various technical documents in the PDF.
Customer Support
CONTEC provides the following support services for you to use CONTEC products more efficiently and comfortably.
Download the latest drivers from CONTEC's Web site to use. In addition, as documents such as precautions are also
provided on the Web site, have a look on CONTEC's Web site.
Name of unit Components and Function
Figure 1 shows the nomenclature of unit components.
POWER LED
SPEED LED SPEED LED
LINK/ACT LED LINK/ACT LED
10BASE-T/
100BASE-TX port
Figure 1 Name of Unit components
LED Indicators
Name Color
ON : Power ON
POWER LED Green
OFF : Power OFF
ON : 100Mbps Link
SPEED LED Orange
OFF : 10Mbps Link, or no link
ON : Link
Flashing : ACT(Data send / Receive)
LINK/ACT LED Green
OFF : No link
Power supply Connector
12-24VDC
Vi+
Vi-
FG
Pin number Signal Description
1 Vi+ Power (12 - 24VDC±5%)
2 Vi- Power (GND)
3 FG Frame Ground
x 2
Setup Guide
Setup Guide
Power supply connector
Content of Display
10BASE-T/ 100BASE-TX Port
8
1
Pin number Signal Description
1
TXP Send (+)
2
TXN Send (-)
3
RXP Receive (+)
4
- No Use
5
- No Use
6
RXN Receive (-)
7
- No Use
8 - No Use
Mounting on a DIN rail
How to Unlock the Fixed Hooks 1
(1) Insert a slotted screwdriver (the point should be smaller than 4.5mm) into a hole (see the figure below).
Precision slotted
screwdriver
(point: 4.5mm or smaller)
insertion hole
(2) By using the screwdriver as leverage, move it upward in the direction of the arrow to unlock.
How to Unlock the Fixed Hooks 2
If your slotted screwdriver is not suitable for the hole.
(1) Place the slotted screwdriver (the point should be smaller than 8mm) as shown in the figure.
Insert the slotted screwdriver (point: 8mm or smaller)
into the position shown in the figure
(between the casing and the arch of the fixed hook).
(2) Rotate the screwdriver 90-degree in either direction.
Rotate the slotted screwdriver.
How to mount
(1) Pull down the fixed hook at the bottom to unlock.
(2) Hang the product on the upper part of the DIN rail, and press it to the lower side of the DIN rail.
(3) Push up the hook to lock.
CAUTION
Confirm whether the product has been securely mounted onto the DIN rail.
SH-8008F Setup Guide